PRO™ is a high-gloss, crystal-clear epoxy resin ideal for creating tumblers, coasters, jewelry, trays, crystals, wood, flood coats, and abstract art! It features a high-viscosity formula that stays where it’s poured to prevent running and spreading when used with glitter. Offering a user-friendly 1:1 mixing ratio, it is low odor and offers maximum UV resistance.
This product cannot currently ship to AK, HI, PR, GU, or Internationally. Shipping to PO box addresses isn't allowed. Free Shipping may be available on this product for orders over $299.00.
- Viscosity: High
- Mix Ratio: 1:1 by volume
- Finish: Glass-like, crystal clear, scratch-resistant finish
- UV Resistant: Yes
- Heat Resistant: 500º F
- Odor: No VOC, low odor formula
- Application Temp.: 70-85º F
- Working time: 45 minutes @ 77º F
- Tack-free Time: 6-8 hours @ 77º F
- Time to Sand: 6-8 hours @ 77º F
- Fully Cured: 72 hours
- FDA Compliant Resin: Yes
- Ideal Application: Tumblers, coasters, jewelry, trays, crystals, abstract art
DIRECTIONS FOR USE:
Ensure the working area is level, clean, dust-free, and dry with a constant temperature between 70°F and 85°F. Avoid working in high humidity.
With gloves on, pour equal amounts of Resin Part A and Hardener Part B into a mixing cup. Add the Resin to the Hardener for optimal results.
Mix both parts together for a minimum of 3 minutes. Scrape the sides and bottom of the cup as you mix. Transfer entire contents into a second container and mix for an additional 1-2 minutes. Once both solutions are added together, you have about 45 minutes before the mixture begins to thicken and cure.
Apply to your surface immediately after mixing until desired thickness is achieved. Bubbles will begin to rise to the surface. Quickly sweep a propane torch or heat gun across the surface, keeping the flame 6-8 inches away. Do not overheat the epoxy resin or hold the heat in one spot for too long.
Allow curing undisturbed in a clean and dust-free environment above 70°. Any dust particles that settle into the surface during curing may cause imperfections. Allow the surface to sit for 4 hours before applying next coat if desired. Epoxy will dry to the touch in approximately 6-8 hours and will fully cure in 72 hours.
CLEANUP - Tools and surfaces can be cleaned with acetone.
For MSDS information, please email email@example.com
Have you used Glitter Chimp glitter to make something amazing? Share a picture here!